-40%
Swiftech G1/4
Swiftech G1/4
Swiftech G1/4

Swiftech G1/4" Male to Male SLI & CrossFireX Adjustable Lok-Seal Fitting, 11-18m

$ 4.75

Availability: 100 in stock
  • Item must be returned within: 30 Days
  • Return shipping will be paid by: Buyer
  • All returns accepted: Returns Accepted
  • Refund will be given as: Money Back
  • Brand: Swiftech
  • Condition: New
  • Type: Fittings

    Description

    G
    ¼
    Male-Male adjustable connector fittings for multiple VGA waterblocks in SLI or CrossfireX. This product is part of the Lok-Seal™ family of fittings.
    Recommended use
    Initial Tip:  If possible, attach the fittings to the cooling devices first! While not mandatory,  it is always preferable to fasten a fitting to a cooling device prior to installing the device inside the case. This will eliminate interference issues that may be encountered when working with tools inside of space constrained enclosures.
    Fasten the fitting by hand until it mates with the surface of the cooling device. The amount of force necessary to screw the fittings down in “finger tight” mating position may vary from one device to another depending on various factors.  Users are advised to always visually check on the actual position of the fitting relative to the device surface rather than solely relying on feel. There should be little -not to exceed the thickness of a sheet of paper, or no visible gap between the fitting lower lip and the device surface
    Dimensions
    For complete long-term safety and leak-free operations, Swiftech® recommends that the fittings be locked in place using the recommended tools and that the torque levels specified below be applied:
    Recommended Torque
    Soft Material
    Minimum
    Maximum (*)
    Acetal (POM) and acrylics
    1/4 of a turn after initial contact between mating surfaces
    1/2 of a turn after initial contact between mating surfaces
    Hard Materials
    Recommended
    Copper, brass, aluminum
    1/8 of a turn after initial contact between mating surfaces
    (*) For full 5mm thread depth – please inspect the device threads prior to applying the maximum
    recommended torque – when partial threads exist due to application necessity, only apply the
    minimum torque.
    Recommended Tools
    A small adjustable wrench with jaw opening up to 1” (25.4mm)
    may be used as a universal tool
    instead of the specific tools listed below
    Specific tool sizes
    Male/male
    Connectors
    Fitting base hex:
    Flat wrench
    Lock Nut
    Flat or adjustable wrench
    G1/4 MMEXT Short (11-18mm)
    Metric: 16mm
    Inch: 5/8”
    N/A
    G1/4 MMEXT Medium (20-33mm)
    Metric: 16mm
    Inch: 5/8”
    Metric: 17mm
    Inch: adjustable wrench
    G1/4 MMEXT Long  (41-65mm)
    Metric: 16mm
    Inch: 5/8”
    Metric: 17mm
    Inch: adjustable wrenc